Lunar Orbiter III Mission

The Lunar Orbiter 3 was a spacecraft launched by NASA in 1967, designed primarily to photograph areas of the lunar surface for confirmation of safe landing sites for the Surveyor and Apollo missions. It was also equipped to collect selenodetic, radiation intensity, and micrometeoroid impact data. The spacecraft was placed in a cislunar trajectory and injected into an elliptical near-equatorial lunar orbit on February 8 at 21:54 UT. The orbit was 210.2 by 1,801.9 kilometres (130.6 1,119.6 mi) with an inclination of 20.9 degrees and a period of 3 hours 25 minutes. After four days (25 orbits) of tracking the orbit was changed to 55 by 1,847 kilometres (34 1,148 mi). The spacecraft acquired photographic data from February 15 to February 23, 1967, and readout occurred through March 2, 1967.


The film advance mechanism showed erratic behavior during this period resulting in a decision to begin readout of the frames earlier than planned. The frames were read out successfully until March 4 when the film advance motor burned out, leaving about 25% of the frames on the takeup reel, unable to be read.
A total of 149 medium resolution and 477 high resolution frames were returned. The frames were of excellent quality with resolution down to 1 metre (3 ft 3 in). Included was a frame of the Surveyor 1 landing site, permitting identification of the location of the spacecraft on the surface. Accurate data were acquired from all other experiments throughout the mission. The spacecraft was used for tracking purposes until it struck the lunar surface on command at 14.3 degrees N latitude, 97.7 degrees W longitude (selenographic coordinates) on October 9, 1967.
Source: Wikipedia

Leave a Reply

Your email address will not be published. Required fields are marked *